Abstract 

Effect of process changes on electric motors. This article explains the effect of changing process loads on AC induction electric motor performance. The motor’s behaviour is a response to the load imposed on it by the equipment connected to it. The equipment’s behaviour is itself a response to the duty and service it has to perform. Where the equipment duty and service is adjustable by the operator, or fluctuates as the process changes, the motor will react to those changes. When the changes are so excessive that they are beyond the motor’s ability to handle them the motor stops and the equipment or process stops with it. Keywords: squirrel-cage motor, overload. [Read more…]

This topic is provided by – Graphic Products, Inc. Contact
info@graphicproducts.com
Copyright © 2000, 2001 All rights reserved.

Abstract

The 5 s method of operation – A Five S program focuses on having visual order, organization, cleanliness and standardization throughout the workplace and the operation. It is a structured method to put operators and maintainers in control of what they do. [Read more…]

6 Secrets of Trouble-free Lubrication Success

Grease and oil are the key lubricants used throughout industry to reduce friction between metal parts. Lubricants can only reduce friction if their immediate environment sustains their lubricating properties. Once the operating conditions are known a suitable lubricant with the right properties can be used. When the lubricant is in place it is necessary to maintain the environment and the machine to the specified design standards and protect it from changes to the design conditions. There are six key factors to address for trouble- free life where grease or oil lubrication is used on machinery. [Read more…]

The Big Bang – starting and stopping equipment under load. When a machine starts-up its parts move from zero speed to operating speed in a short time (the reverse when stopping). During this short period the biggest forces that the machine experiences act on its components. If during the start-up or slow-down the product or process loads are added to the machines own self-loads the forces acting on the machine’s parts are horribly magnified. If these impulse forces exceed the machine’s design allowance, or cause gradual fatigue, then the stressed parts will shatter without warning. [Read more…]

Rotating shafts under bending stress. It is common to transmit motion using rotating shafts. The shafts are mounted in bearings and turned by force through a drive arrangement. The shafts usually also carry a load. These loads cause bending and the shaft reacts by producing counter stresses within itself. Provided the reactive stresses are within the shaft’s strength range it will take the load. But if the stresses are greater than what the shaft can take it will bend. Even if the stresses are below the load limit but fluctuate, it is possible that the shaft will break from fatigue. The point of highest stress can be found by looking at the arrangement of the shaft supports and loads and calculating the forces and stresses.
[Read more…]

Orifice plate meter flow measurement. An orifice meter is a circular piece of metal plate placed between flanges in a pipe. In it is a square-edged round hole machined 0.5 to 0.8 pipe diameter in size. Pressure tapping points are placed either side of the plate at specified distances. The orifice causes a flow restriction and produces a pressure drop from one side of the hole to the other. The amount of pressure difference is proportional to the flow of fluid through the hole. The flow is calculated from the pressure difference and flow areas using accurate mathematical formulas. [Read more…]

This topic is provided by  http://www.isixsigma.com/library/

It’s important when resolving a problem that you address the problem and not a symptom of the problem. Determining the real problem is called finding the root cause. There are special techniques for determining the root cause of a problem. One technique is known as “The 5 Whys.” [Read more…]